briggsadmin
06-18-2007, 01:04 PM
I just flashed my k1m from uscc to the bell firmware.
When I have the phone set in the connection>USB Settings to USB Drive, The phone still acts as if it is set as Modem/COM.
When I was on the USCC flash and it was set to that, the computer would see it as if it was like a usb thumbdrive and i could write directly to my SD card from within windows. It would be as if it was a drive on the computer. No extra drivers were needed. It was very nice.
I am guessing there is a seem edit to enable this, but I am not sure. ANyone have any ideas on this?
When I have the phone set in the connection>USB Settings to USB Drive, The phone still acts as if it is set as Modem/COM.
When I was on the USCC flash and it was set to that, the computer would see it as if it was like a usb thumbdrive and i could write directly to my SD card from within windows. It would be as if it was a drive on the computer. No extra drivers were needed. It was very nice.
I am guessing there is a seem edit to enable this, but I am not sure. ANyone have any ideas on this?