flash v3

[tarong]

ppl,i want to know what type of mp i can flash on v3 with bootloader 07.e0 and sw version
r374_g_oe_79r

[AlucardArg]

It would be best if you flashed the BL version 07.D0. It's compatible with most MPs and stuff.
Check the DL section. The MP's descriptions usually say which BL they are compatible with.
Of course, always flash R374 MPs. Otherwise, you'd get a very cute paperweight :D

[Tony]

nope not a paperweight you will just have to perform surgery on the phone

[AlucardArg]

well... of course... but until then, it'd be a brick...

[Tony]

testpoint is a very simple process the one in this example is an l7 but it is exactly the same process YouTube - testpoint motorola slvr L7

[tarong]

ok.but as we have 42r for all in e398 do we have for v3? when i brick it hope i will not have much problems to make it work.i just need a simple way

[chucho_gt]

dont be negative! if you are careful and read before flashing and check that the bootloader is the same, you will not brick it.
you could use scottys boot downgrader to downgrade it to 7D0 and then you could flash most of the flash´s...

[AlucardArg]

If you read the guides, and so a little research, you won't brick it!
but, remember to always backup everything! just in case... :p

[zedbra]

Yep, knowledge is power:) Read, Read, Read!!! of course a good way to learn what NOT to do is to read the experiences here in the forum. I think it is important to know as much about bricking as possible, this way you can avoid making the same mistakes so many of us have made. Also i have found that 80% of the time, you dont need to do a testpoint on the v3(r374) to un-brick it. although tricky, it sure beats risking damage to the phone.
Good luck!! and remember if you screw up..... there is plenty of help at MMM:D