keypad gone mad

[chucho_gt]

hi, yesterday i completely change all the housing of my girlfriend V3 ALL OF THEM.
when i was taking out the key pad circuit board, i realise that it was glued to the housing so I lift it up and start to cut the glue, when i put it to the new housing and then installed the new keypad, keys 9 and the D pad (up, down, left, right) did not function, I disassembly again and cleaned all contacts but nothing, what do you recommend?

[candymanmike]

first step would be to take it apart again and make sure its plugged in tight. then i would check it really closely to make sure you didn't damage anything. you may end up buying a new keypad. they're cheap.

[krawls80]

Hey guys, wat is that cable that hangs at the bottom of the keypad circuit board and does it suppose to connect to anything?

[chucho_gt]

that cable is the microphone.
so, i did take it apart (4 times) and still nothing.
how can i know if there is something damaged (i didn´t see anything)
i cleaned all the contacts and the keyboard too

[Tony]

maybe a damaged cable somewhere i know the original v3 had alot of issues with the keypad

[xxalexisrulesxx]

sorry chucho its not the microphone even thought it looks like it so remember if your mic doesnt work its either sw or ypur motherboard because your microphone in soldred onto your microphone, (btw its the one with the small shielding on the side that has a hole in it that is covered with a thin layer of rubber)

[motoman23]

its really hard to see damage to a flex cable it could just be a small crack in a circuit best thing to do is just replace it like candymike said there cheap!!