my new paperweight (v3re)

[nbleasdale]

Righto, so i think i've managed to brick my missus' new v3re, using fb3 and more than likely wrong firmware.

I'm just a dumbass cos i think i was a bit confused when i first got it thinkin it was just your run of the mill v3, duur.

Anyway I'm guessing, (now that i've sorted the right profiles for the v3_06 on fb3) the only way to sort it is to reflash with identical s/w, ie. R3442A_G_0E.41.22R that was on it originally? If so, what's the likelehood of me actually getting my hands on that.......

Any thoughts appreciated, ta very much

[HeyItsTJ4]

Here is the link http://www.modmymoto.com/forums/down...o=file&id=7252

[Tony]

flash it u should be fine if not let us know

[98xploder]

thanks captain obvious. ^^^^

[nbleasdale]

Hmmm tried the link and while it seemed to flash fine using fb3, it's still buggered. Still seems to show original r3442a_g_0e.41.22r when switched on in flash mode. not only that but also has PH SIG ERR: 35:02: now too.

[98xploder]

try flashing it again with rsdlite.

[nbleasdale]

Yep, same story with RSD lite, while it appears to have flashed sucessfully, says same thing on the handset and will only start in flash mode....

[dharmasattva]

OK so I bricked my v3re and have tried reflashing.

I get the error message 35:02. By the way, when I turn on the phone, I get "Hellomoto" then it immediately turns off.

Help!!!!!



OK - I finally was able to revive my phone by reflashing the software.

Now it won't pick up AT&T's network.

Any ideas?

[V34ME]

dharmasattva, dig through the posts from the last couple weeks. I read another thread where someone had the same connectivity issues after reflashing their V3re. The solution was to then flash an original copy of the DRM CG. There was a link to this file on some share site. It's worth a shot.

[dharmasattva]

I looked and looked but could not find the original DRM for the AT&T branded V3re.

[Digital1980]

I don't like it when people post about information that has already been discovered. These are the same people who make forums so damn hard to navigate and find what you are looking for.

Thanks making for it harder for noobs like me to learn! Of course, the starter of this thread is even more of a noob because he failed to read a few simple instructions.

[dharmasattva]

I am not sure if that comment was intended for me.

I am simply looking for some assistance. If the assistance I'm looking for has already been given out elsewhere, I would be grateful if someone could point me to it.

Thanks in advance,

D.S.

[V34ME]

Perhaps Digital1980 would make you a CG of his DRM. His sig says he has an AT&T V3re. What do you say Digital? Can ya help this guy?

[dharmasattva]

Originally Posted by V34ME

Perhaps Digital1980 would make you a CG of his DRM. His sig says he has an AT&T V3re. What do you say Digital? Can ya help this guy?

I'm a girl, BTW

Thanks, Digital1980, in advance!!!!

D.S.

[Phyrst]

my fiances v3r is a paper weight too. it won't even cut on so rsdlite won't even recognize it. the keys just light up when you try to power it on but it does NOTHING ELSE. my razr finally bricked after 3 years i had the v3 (blue cingular model) and it just would not stop hitting keys when I talked on it.. I chunked it off the bridge somewhere