I wrote this because i´ve seen too mucho got disapointed about e2 trough a 3.5mm to RCA adapter and other speakers; this guide works for 3.5 mm to rca adapter as good as with any other cable adapter i mean they´re just cables.

my first try was iverting the polarity of the cable, taking one and cutting it then inverting the cables but this was cool but just not as perfect as this mod, although it was not posible to use the cable with other devices like my laptop, i could hear just one speaker and this was not so cool. and i got inspired with my resistor classes last week.

someone overhere wrote something similar but it was harder.. though! and it was just not so graphic.
HERE YA GO!

Materials:
-A ROKR E2
-3.5MM TO RCA cable
-ISOLATING TAPE

-6.8 Kohm RESISTOR (whatever... i tried lots of resistors and i dindt see any difference just chose a tiny one )



Procedure:

1. cut one end of the RCA cable, you´ll see to cables inside just like here:

2. place the resistor on it and secure it:

3. isolate it with the isolation tape:

4: THIS IS THE FINAL AND MOST IMPORTANT; enjoy your music bugging your little brother at the highest volume of your home audio system